Rosslare AC-215 Manual do Utilizador descarregar pdf (Página 9)

7. From the Antipassback dropdown list select the control mode of double pass through the

readers (Figure 3.4-2, 6).

Table 3.4-1 Description of pass modes

Pass mode

Description

Hard

If pass procedure is violated when the double pass is controlled then user access is forbidden and

alarm is transmitted to the computer.

Soft

If pass procedure is violated when the double pass is controlled then user access is allowed and

alarm is transmitted to the computer.

8. In order to control the double pass set the checkboxes opposite corresponding readers (Figure

3.4-2, 7).

9. To save changes click Apply (Figure 3.4-2, 8).

Configuration of Rosslare controller is completed.

3.5 Configuration of Rosslare access points

Program models of the following devices are supported in Rosslare ACS:

1. Door with one-sided access control.

2. Door with double-sided access control.

For correct operation of ACS equipment it’s necessary to configure access points (door) and devices

belonging to them – readers, entrances, exits.

АС-215 controller can serve either one double-sided door or two doors with one-sided access control.

Note. One can create unlimited quantity of the Door objects, but only those that have an address will

function (Number parameter).

3.5.1 Configuration of entrances

Configuration of АС-215 controller entrances is performed on the setting panel of the Rosslare

entrance object. This object is created on the basis of the AC-215 controller object on the Hardware tab

of the System settings dialog box (Figure 3.5-1).

Figure 3.5-1 The Rosslare entrance object

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Sem comentários

Rosslare AC-215 Manual do Utilizador Página 9